Pelco DX9100 User Manual download pdf (Page 66)

66 C636M-E (4/05)

Figure 81. CM9760 Relay Configuration Dialog Box

6. Set the baud rate to 9600 and the parity to Even. The relay unit should have these same settings.

7. Enter 1 in the COM Port field. This is the port on the recorder that connects to the relay unit. The system defaults to COM 2.

8. Set the default latch time. This time activates the relays on the relay unit and sets the same latch time for all of the relay

ports. The default is 5 seconds.

NOTE: Frame Address is not used. The default value is 0.

9. Add latch times for specific relays.

10. Click OK.

11. Click Test.

12. Close the I/O Handler Configuration application.

Figure 80. Device 1 Relay Driver Dialog Box

5. Click Configure. The following dialog box appears.

4. Click Open. The following dialog box appears.

1 2 ... 61 62 63 64 65 66 67 68 69 70 71 ... 85 86

No comments

Pelco DX9100 User Manual Page 66