INSTALLATIONC3453M-C (5/09)EH1512 Enclosure with EM1512 Mount EH1512 Series Enclosures
10 C3453M-C (5/09)17. Adjust the camera focal length and focus, if necessary.Figure 5. EH1512 Wiring Diagram18. Position the enclosure lid and close
C3453M-C (5/09) 11INSTALLING THE SUN SHROUDThe optional sun shroud fits over the top of the EH1512 enclosure. Perform the following steps to install t
12 C3453M-C (5/09)Table C describes the recommended maximum distances for 24 VAC applications, which are calculated with a 10 percent voltage drop. (T
C3453M-C (5/09) 13SpecificationsMECHANICALCamera Mounting Single slot for adjustable camera positioning on snap-in camera sledCamera and Lens Size Acc
14 C3453M-C (5/09)RECOMMENDED CAMERAS AND LENSESCameras C10CH-6, C10CH-6X, C10CH-7X, C10DN-6, C10DN-6X, C10DN-7X, CCC1390H-6, CCC1390H-6X, IP3701H-2,
PRODUCT WARRANTY AND RETURN INFORMATIONWARRANTYPelco will repair or replace, without charge, any merchandise proved defective in material or workmansh
Pelco, Inc. Worldwide Headquarters 3500 Pelco Way Clovis, California 93612 USAUSA & Canada Tel (800) 289-9100 Fax (800) 289-9150Internatio
2 C3453M-C (5/09)ContentsImportant Safety Instructions . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
C3453M-C (5/09) 3Important Safety Instructions1. Read these instructions.2. Keep these instructions.3. Heed all warnings.4. Follow all instructions.5.
4 C3453M-C (5/09)DescriptionThe EH1512 Series indoor/outdoor enclosures are designed for use with small- to medium-sized analog and IP cameras. They w
C3453M-C (5/09) 5OPTIONAL ACCESSORIESBlower KitEH1512-1BKIT Continuous duty, 120 VAC, 1 W, 1.45 cfmEH1512-2BKIT Continuous duty, 24 VAC, 1 W, 1.45 cfm
Figure 1. Package Contents6 C3453M-C (5/09)PACKAGE CONTENTSNOTE: A metric Allen wrench (5 mm) is required for installation but is not included. A Ph
C3453M-C (5/09) 7InstallationINSTALLING THE OPTIONAL SECURITY KITThe optional security kit (EH-SKIT) contains three tamper-resistant screws and a 1/8-
Figure 3. Removing the Sled8 C3453M-C (5/09)3. Remove the camera sled from the enclosure rail (refer to Figure 3).a. Squeeze the two plastic tabs (lo
C3453M-C (5/09) 98. (EM1512 mount only) Attach the mount to the wall:a. Use the mount as a template to mark and drill holes in the mounting surface.b.
Comments to this Manuals