Pelco Switch C1566M-C User Manual download pdf (Page 100)

C1572M (9/05) 99

CM9760-DFC REAR PANEL DOWNFRAME CARD

The CM9760-DFC rear panel card (refer to Figure 53) is used in a downframe conﬁguration. The card is installed in every bay between the ﬁrst

and last bay to connect the associated intermediate bays. The card can also be used in the last bay if looping is not required.

NOTE: Unlike the CM9760-DFL downframe card, the CM9760-DFC downframe card does not provide the ability to loop out video.

The CM9760-DFC card connects to a CM9760-VCC video input card, which is installed into the front of the matrix bay.

A downframe cable is supplied with the CM9760-DFC card. For additional information about downframing, refer to the Downframing section.

Figure 53. CM9760-DFC Downframe Card

As illustrated in Figure 53, the CM9760-DFC card includes the following:

• Termination Jumpers JP1-JP16: Allow video to be terminated (jumper positions 1 and 2) or unterminated (jumper positions 2 and 3):

– When CM9760-DFC cards are used in intermediate bays, termination jumpers must be set in the unterminated position.

– When CM9760-DFC cards are used in the last bay, termination jumpers must be set in the terminated position.

Termination jumpers are set in the appropriate position when your system is conﬁgured at the factory. However, if you change your

system—for example, add or replace a card—you may need to change the termination.

• Input Connector: Thirty-two pin male connector that connects to a downframe cable, which then connects to the rear panel card in the bay

above.

• Output Connector: Thirty-two pin male connector that connects to a downframe cable, which then connects to the rear panel card in the bay

below.

CM9760-DFC Card Guidelines

The following guidelines apply to the CM9760-DFC card:

• Within each bay in a downframe conﬁguration, up to 16 CM9760-DFC cards can be inserted into 16 possible slot positions that are

associated with the slot positions of the corresponding CM9760-VCC cards.

• The CM9760-DFC must be installed before the associated CM9760-VCC video input card is installed into the front of the matrix bay.

• When installing a new card, termination jumpers must be set in the proper position: terminated or unterminated.

UNTERMINATED

TERMINATED

OUTPUT

TO BAY BELOW

INPUT

FROM BAY ABOVE

1 2 ... 95 96 97 98 99 100 101 102 103 104 105 ... 148 149

No comments

Pelco Switch C1566M-C User Manual Page 100