Pelco Translator Board TXB-AD User Manual download pdf (Page 11)

C1492M-I (8/05) 11

Figure 7.

Receiver Location

3. Set DIP switches on the TXB-AD. Refer to Figure 6 and Table A.

4. Install the TXB-AD board. Refer to Figure 8 and Figure 9 and do the following:

a. Open the hinged door to the back box. Push the tab lock towards the wall of the unit and

lift the door open.

b. Remove the shorting plug from the 16-pin connector located on the Spectra system’s

circuit board.

NOTE:

Do not discard the 16-pin shorting plug. Save the plug in case the system is converted back

to a Pelco-controlled unit.

c. Insert the TXB-AD translator into the 16-pin connector located on the dome system’s

circuit board.

d. Secure the translator board to the standoff on the interconnect circuit board using the

provided 4-40 (Spectra II) or 6-32 (Spectra III) screw and lock washer.

AMERICAN DYNAMICS

CONTROLLER

AMERICAN DYNAMICS

CONTROLLER

PTZ

PTZPTZPTZPTZPTZ

PTZ PTZ

PTZPTZPTZPTZ

LINE

RECEIVERS

EXAMPLE OF STAR CONFIGURATION WITH DAISY CHAIN

RECEIVERS

EXAMPLE OF DAISY-CHAIN CONFIGURATION

= TERMINATED = UNTERMINATED

LINES 1-5 MUST NOT TOTAL MORE THAN 4,000 FT (1,219 M)

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 31 32

No comments

Pelco Translator Board TXB-AD User Manual Page 11