Pelco PMC14EX User Manual download pdf (Page 12)

10 Pelco Manual C929M-B (2/97)

4.0 OPERATION

There are two sources of video and audio input:

• VTR (video tape recorder)

•Video 1 and Video 2

Only one source can be selected at a time.

To select the input from a video recorder, set the VTR/VIDEO switch on the front

panel in the VTR position. In this position, the video and audio signals are sent to

the monitor and through the OUTPUT connectors to any equipment connected to

them.

To select the input from Video 1 and/or Video 2:

1. Set the VTR/VIDEO switch on the front panel in the VIDEO position.

2. Set the AUTO/MANUAL switch to MANUAL if you are using only one input

(input 1 or input 2). Then set the VIDEO 1/VIDEO 2 switch for the input that

you are using.

If you are using inputs 1 and 2, set the AUTO/MANUAL switch to MANUAL if

you want to switch between the inputs manually using the VIDEO 1/VIDEO 2

switch.

If you are using inputs 1 and 2, set the AUTO/MANUAL switch to AUTO if you

want the monitor to switch back and forth automatically between the two in-

puts. The VIDEO 1/VIDEO 2 switch is non-functional. Adjust the dwell time for

switching between inputs 1 and 2 with the TIME knob.

When the VTR/VIDEO switch is in the VIDEO position, the video and audio signals

are sent to the monitor and through the OUTPUT connectors to any equipment

connected to them. The signals are also transmitted to the VTR output jacks for

recording.

4.1 PASSIVE LOOPING

If you are using Input 1 and are looping the signal through the IN and OUT connec-

tors (passive looping) (refer to Figures 4 and 5), the monitor does not have to be

turned on unless you want to watch the monitor.

1 2 ... 7 8 9 10 11 12 13 14 15 16

No comments

Pelco PMC14EX User Manual Page 12