Pelco DX4600 User Manual download pdf (Page 19)

C2673M-D (8/10) 19

Hardware Setup

BASIC CONNECTIONS

NOTE: Refer to the KBD300USBKIT Installation manual for information about installing the KBD300A keyboard.

To make the basic equipment connections to the DX4500/DX4600, refer to Figure 8 and do the following:

1. Connect the USB mouse to the bottom USB connector. The mouse allows you to operate the DVR using the GUI and on-screen PTZ control.

2. Connect a VGA monitor (not supplied).

3. Connect the cameras to the BNC connectors. Refer to Table D for video coaxial cable requirements. Connect power to the cameras.

4. Connect the appropriate power cord to the back of the unit and to a power source. The DX4500/DX4600 contains an autoranging power

supply. It is recommended that the recorder be connected to an uninterruptible power supply (UPS) capable of supplying 2 A for 120 VAC

power systems or 1 A for 230 VAC power systems.

Figure 8. Basic Connections

NOTE: You might experience operational issues when a camera device is not correctly terminated. When connecting camera devices, use a

normal load termination of 75 ohms. When looping through DVR inputs, ensure that the signal is terminated at the end device. For additional

information about terminating a specific camera device, refer to the device’s installation manual.

The following table describes the coaxial cable requirements.

Table D. Video Coaxial Cable Requirements

Cable Type* Maximum Distance

RG59/U

RG6/U

RG11/U

750 ft (229 m)

1,000 ft (305 m)

1,500 ft (457 m)

*Cable requirements:

75-ohms impedance

All-copper center conductor

All-copper braided shield with 95% braid coverage.

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 39 40

No comments

Pelco DX4600 User Manual Page 19