Pelco DX7100 User Manual download pdf (Page 7)

C641M (11/03) 7

BASIC INSTALLATION

Basic installation covers all the equipment necessary to program and operate the system. Refer to the

Extended Installation

section for PTZ, alarm, sensors, and network connections.

115

230

DSP Color CCD Camera

Verify that the

voltage is set

correctly for

your location

NTSC

PAL

Figure 3. Basic Equipment Installation

1 Set the Voltage Selection Switch - Verify that the voltage selection switch is set correctly for your location. This product

is set at the factory to operate on 115 VAC. For 230 VAC operation, move the switch to the 230 VAC position before

applying power to the unit.

2 Connect the power cord to the AC input located on the back panel. Plug the other end of the power cord into an AC outlet.

3 Connect the keyboard to the bottom PS/2 input.

4 Connect the mouse to the top PS/2 input.

5 Set the NTSC/PAL switch (DX7108 models) or switches (DX7116 models) to the correct camera setting for your location.

6 Connect the SVGA monitor (not supplied).

7 Connect the cameras. Refer to the following table for video coaxial cable requirements:

Video Coaxial Cable Requirements

Cable Type* Maximum Distance

RG59/U 750 ft (229 m)

RG6/U 1,000 ft (305 m)

RG11/U 1,500 ft (457 m)

* Minimum cable requirements:

75 ohms impedance

All-copper center conductor

All-copper braided shield with 95% braid

coverage

1 2 3 4 5 6 7 8 9 10 11 12

No comments

Pelco DX7100 User Manual Page 7