Pelco CC3600 User Manual download pdf (Page 8)

[ 8 ] Pelco Manual C1981M-C (8/02)

POWER AND VIDEO CONNECTIONS

To connect the camera power and video do the following:

1. Remove the rear cover from the camera (refer to Figure 1). Thread cabling through the rear cover.

2. Connect the power cable to the two pin power connector on the back of the camera using the

terminal block connector provided. Refer to Table A for the recommend wire gauge to use for

the installation.

3. Connect a video cable to the SIGNAL OUT connector (BNC) on the back of the camera. Refer to

Table B for the type of video coaxial cable to use.

4. Reattach the rear cover to the back of the camera.

Power Connections

CC3500 and CC3600 Series cameras are designed to operate from a 12 VDC or 24 VAC power sup-

ply. The power supply connections are shown in Figure 4. The LED on the back panel of the camera

indicates that power is connected. Use only a Class 2 isolated power supply. Power consumption is

less than 5 watts.

Figure 4. Power Supply Connections

To connect the camera power and video:

1. Remove the cosmetic trim ring from the camera (refer to Figure 1). Thread cabling through the

rear cover.

2. Connect the power cable to the two pin power connector on the back of the camera using the

terminal block connector (provided). Refer to Table A for the recommend wire gauge and wiring

distances.

3. Connect a video cable to the SIGNAL OUT connector (BNC) on the back of the camera. Refer to

Table B for the type of video coaxial cable to use.

4. Reattach the trim ring to the back of the camera.

24 VAC 12 VDC

CLASS 2

ISOLATED

POWER

SUPPLY

CLASS 2

ISOLATED

POWER

SUPPLY

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16

No comments

Pelco CC3600 User Manual Page 8