Pelco Espirit ES30TI User Manual download pdf (Page 11)

C1307M-C (8/07) 11

9. Plug the male Esprit system connector, located on the bottom of the pan/tilt, into the female Esprit system connector located on the

transformer module. Align the pan/tilt part number with the alignment label of the base and then attach the pan/tilt to the base with three

1/4-20 nuts and washers (supplied).

Figure 6. Attaching Base and Pan/Tilt

10. Set the receiver address and system baud rate by configuring DIP switches SW1 and SW2.

NOTE: If you have a Coaxitron controller, you do not have to set the DIP switches. The Esprit will sense and automatically select settings

from Coaxitron control signals in either standard or extended mode.

To set the DIP switches:

a. Remove the plug from the left cover of the pan/tilt. It is not necessary to remove the pan/tilt cover.

b. Set the baud rate (SW1) and receiver address (SW2). For switch settings refer to the labels located in Table A on page 54 and Table C

on page 55.

c. Replace the plug.

Figure 7. Setting DIP Switches

11. Refer to Operation on page 14 and Programming on page 17 for instructions on how to use your ES30TI Series Esprit integrated positioning

system.

PART

NUMBER

MALE SYSTEM

CONNECTOR

ALIGNMENT

LABEL

FEMALE

SYSTEM

CONNECTOR

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 59 60

No comments

Pelco Espirit ES30TI User Manual Page 11