Pelco DF8 User Manual download pdf (Page 6)

6 C2433M-D (9/06)

SURFACE MOUNT

NOTE: If installing outdoors, apply a sealant between the back box and the mounting surface.

1. Unscrew the three Phillips screws located inside the back box. Remove the top portion of the back box.

Figure 2. Removing the Top Mount from the Back Box

2. Determine the mounting location. Use the base of the back box as a template. Mark the fastener and center hole positions onto the

mounting surface.

3. Prepare the holes for the wiring and fasteners.

4. Prepare the wiring for camera and lens power; refer to Table A and Table B for wiring distances.

5. Position the back box over the mounting holes and pull wiring into the back box. Secure the back box to the mounting surface using the

appropriate hardware for your installation.

Figure 3. Installing the Surface Mount Back Box

1 2 3 4 5 6 7 8 9 10 11 12

No comments

Pelco DF8 User Manual Page 6