Pelco PT55OP User Manual download pdf (Page 10)

10 Pelco Manual C325M-C (6/99)

Figure 5. Limit Stops

3.4 LIMIT STOP ADJUSTMENTS

To set pan/tilt limit stops, perform the following steps. Refer to Figure 5.

1. Loosen the pan limit stops.

2. Turn the control unit on. Pan the unit to the right until the desired right pan limit

is reached.

3. Move the right pan limit stop until it touches the pan limit switch actuator. Move

the stop a slight distance further against the actuator until it clicks to indicate

the opening of the limit switch. Lock the stop in place.

4. Pan the unit to the desired left position. Adjust the left pan limit stop as de-

scribed in step 3.

5. Pan left and right to both limit stops and check for exact positioning. Tighten

both stops securely.

6. Remove the cover plate from the left side of the tilt table. Loosen the limit stop

screws and tilt the table, using the joystick, to the desired up position.

7. Move the up limit stop until it touches the tilt limit switch actuator and clicks.

Lock the stop in place.

8. Tilt the table to the desired down position and set the stop in the same manner.

9. Tilt the table up and down and check for exact positioning. Tighten both stops

securely. Replace the cover plate.

WARNING:

Do not

operate the pan/tilt

without limit stops.

Do not attempt to adjust

the limit stops while the

unit is operating. Per-

sonal injury or damage

to the unit may result.

Do not

remove or reposition the

fixed limit stop on the pan/tilt.

DAMAGE WILL OCCUR.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 16

No comments

Pelco PT55OP User Manual Page 10