Pelco IS150 User Manual

INSTALLATIONC3427M-C (10/07)IS150 SeriesCamclosure®Integrated Camera System

10 C3427M-C (10/07)SUSPENDED CEILINGNOTE: You should install the camera module into the back box before installing the back box into the surface. When

C3427M-C (10/07) 114S DEEP ELECTRICAL BOXNOTE: You should install the camera module into the back box before installing the back box into the surface.

12 C3427M-C (10/07)Camera ModuleThe IS150 Series Camclosure camera module includes the camera, camera bracket, and heater board. To perform most camer

C3427M-C (10/07) 132. Unplug the camera (10-pin), service (3-pin), and heater board (4-pin) connectors from the back box (refer to Figure 6).Figure 6.

14 C3427M-C (10/07)CAMERA ORIENTATIONAt the factory, the camera module is configured for ceiling mounting. For wall mounting, you must change the came

C3427M-C (10/07) 15Camera AdjustmentsTo perform the following camera adjustments, make sure to plug in the camera and service connectors. You may have

16 C3427M-C (10/07)DN/CH SERIES ADJUSTMENTSRefer to Figure 9 to adjust the IS150-DN or IS150-CH model.Figure 9. Adjusting the IS150-DN/CH Series Camc

C3427M-C (10/07) 17SW4-4: FlickerlessIn certain lighting conditions, a flicker in the light source may affect camera operation. Flickering can be caus

18 C3427M-C (10/07)VERTICAL PHASE ADJUSTMENTNOTE: Use this procedure for 24 VAC operation only.When using more than one camera power supply, a brief v

C3427M-C (10/07) 19DAY/NIGHT OPERATIONNOTE: This section only applies to DN model cameras.DN model cameras regularly check the brightness level of the

2 C3427M-C (10/07)

20 C3427M-C (10/07)DW/CW SERIES (WIDE DYNAMIC RANGE) ADJUSTMENTSRefer to Figure 11 to adjust the IS150-DW or IS150-CW model.Figure 11. Adjusting the

C3427M-C (10/07) 21SW1-4: AWB (Auto White Balance)/MWB (Manual White Balance)Auto white balance is enabled by default (ON).To manually set and lock th

22 C3427M-C (10/07)SW1-8: Day/Night Operation (DW models only)NOTE: On CW models, SW1-8 is unused and does not affect camera operation.DW model camera

C3427M-C (10/07) 23AUTO IRIS LEVEL ADJUSTMENTThe electronics of the IS150-DW and IS150-CW Series Camclosures automatically adjust the camera to the au

24 C3427M-C (10/07)Camera PositioningRotate and tilt the camera module to position the camera. Then tighten the tilt screws (axis ì in Figure 13).NOTE

C3427M-C (10/07) 25Install Liner and Trim Ring1. Adjust the liner if installed (refer to Figure 14):a. Align the screw holes in the trim ring with tho

26 C3427M-C (10/07)Service ConnectorThe IS150 Series Camclosure integrated camera system includes a service connector that outputs camera video. Use i

C3427M-C (10/07) 27To assemble the cable:1. Attach the CPM 88 miniature coaxial connector to one end of the cable. Follow the directions supplied with

28 C3427M-C (10/07)SpecificationsGENERALPan/Tilt Adjustment ManualPan 360°Tilt 80° (20° to 100° range) Rotation 360°Construction Aluminum with steel c

C3427M-C (10/07) 292.42(6.15)1.75(4.45)3.50 (8.89)5.48 (13.92)NOTE: VALUES IN PARENTHESES ARE CENTIMETERS;ALL OTHERS ARE INCHES.3.75 (9.53)

C3427M-C (10/07) 3ContentsRegulatory Notices. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

30 C3427M-C (10/07)

PRODUCT WARRANTY AND RETURN INFORMATIONWARRANTYPelco will repair or replace, without charge, any merchandise proved defective in material or workmansh

Worldwide Headquarters3500 Pelco WayClovis, California 93612 USAUSA & CanadaTel: 800/289-9100Fax: 800/289-9150InternationalTel: 1-559/292-1981Fax:

4 C3427M-C (10/07)List of Illustrations1 Package Components . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

C3427M-C (10/07) 5Regulatory NoticesThis device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this

6 C3427M-C (10/07)DescriptionThe IS150 Series Camclosure® integrated camera system combines an environmental cover, back box, camera, lens, and lower

C3427M-C (10/07) 7Indoor/outdoor dome, vandal resistant, in-ceiling mount, clear bubble, liner, gray finishPARTS LISTCamera Type Lens/Iris NTSC PALCol

8 C3427M-C (10/07)Figure 1. Package ComponentsBACK BOX (1)CAMERA MODULE(1)TRIM RING, LINER, AND CLEAR BUBBLE(1)TRIM RING ANDSMOKED BUBBLE(1)<

C3427M-C (10/07) 9Cover and Back Box InstallationThe IS150 Series Camclosure integrated camera system mounts only into a wall or ceiling.UNSHIELDED TW