Pelco DX8100 User Manual download pdf (Page 25)

C2639M-B (8/09) 25

Reinstalling the DX8100

1. Replace the chassis cover using the screws you removed from the sides and rear of the unit (refer to

Figure 1 on page 8).

2. Attach the silver product label for your upgrade kit to the inside of your unit front door.

NOTE: In the event that your unit or its components require service, specific labels must be present

and appropriately affixed to the unit’s door. Pelco product support personnel use these labels to

identify the exact components installed in your system. A separate product label is required for each

upgrade component installed on the DX8100.

3. Reinstall the unit in a rack enclosure, if necessary, and reconnect all of the cables and peripheral

equipment you removed earlier.

To complete the installation procedure, you must allocate the system and data drives.

• Allocating a system drive data partition and data drive: Refer to Allocating a System and Data

Drive Simultaneously on page 26.

• Allocating a video data drive: Refer to Allocating a New Video Data Drive on page 28.

1 2 ... 20 21 22 23 24 25 26 27 28 29 30 31 32

No comments

Pelco DX8100 User Manual Page 25