Pelco Door ECP290 User Manual download pdf (Page 10)

*See Tip Wizard

on page 13

STEP 4

You must now inform the Door Controller of the Site Code of the Access Passes supplied.

The Site Code is always stored in Slot N

. 01.

The Site Code is always a 5 digit number.

Check the Access Pass Information Sheet delivered with the Access Passes. It will tell you the Site Code of the Access

Passes delivered.

Example: Site Code = 45801

After a beep enter on the TELPRO:

A sharp beep confirms that you have correctly entered the Site Code. Programming mode beep - every 4 seconds -

resumes.

*KBP Proximity Cards have the full site code printed on each card.

STEP 5

You must now inform the Door Controller of the Access Pass Holder Numbers supplied.

Check the Access Pass Information Sheet delivered with the Access Passes. It will tell you which Holder Numbers we

have supplied.

Example: 150n

. Access Passes Supplied........HOLDER NUMBERS 001-150.

After a beep enter on the TELPRO:

A series of 3n

. beeps followed by a sharper beep confirms that you have correctly entered the Holder Numbers.

Programming mode beep - every 4 seconds - resumes.

STEP 6

Turn off programming switch SW1 in the Door Controller. You have successfully programmed the system. The Access

Passes should now all work.

ADVANCED PROGRAMMING

In the following examples of programming we are assuming that the Master Code = 19388. This is purely for

demonstration purposes. When programming for real, you must enter the Master Code that you chose and set when

the system was installed.

Example A: Block Loading/Validation of Access Passes.

You have just received an additional 25n

. Access Passes for the system. Holder Numbers 151- 175.

Enter the Master Code 19388 on the TELPRO. Beeps every 4 seconds indicate that you have accessed Programming

Mode.

After a beep enter on the TELPRO:

A series of 3n

. beeps followed by a sharper beep confirms that you have correctly entered the Holder Numbers.

Programming mode beep - every 4 seconds - resumes.

Example B: Deletion of 1n

. Access Pass

You have just been informed that Alan Jones has lost his Access Pass. Alan was Holder Number 074. You have to

delete it immediately to restore system security. Enter the Master Code 19388 on the TELPRO. Beeps every 4 seconds

indicate that you have accessed Programming Mode.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 19 20

Comments to this Manuals

No comments

Pelco Door ECP290 User Manual Page 10

Comments to this Manuals