search

Pelco Door ECP290 User Manual Page 9

  • Download
  • Add to my manuals
  • Print
  • Page
    / 20
  • Table of contents
  • BOOKMARKS
    • Rated. / 5. Based on customer reviews
Page view 8
9
PROGRAMMING
08
Example
Basic configuration,
just do it!
Basic configuration,
just do it!
seconds
ECP Door Controller with
ACCESS PASS CONTROL
TOP POINTS TO REMEMBER
■ Programming is effected via the TELPRO programming keypad.
■ Site Code is always a 5 digit number.
■ Site Code is always stored in Slot N
o
. 01.
■ Master Code (Programming Access Code) is always a 5 digit number.
■ Master Code is always stored in Slot N
o
. 06.
TIP - WHEN YOU ARE PROGRAMMING
It is a good idea to have written down in advance what you want to program. Enter the numbers in quick succession
after a beep. Do not wait more than 2-3 seconds in between entering numbers as this will confuse the system.
SET-UP ON INSTALLATION
Wire up according to appropriate electrical wiring schematic for your installation, then power up the Door Controller.
Flick the
Programming Switch SW1. The unit will start beeping every 4 seconds.
STEP 1
Decide Now -- For how many seconds do you want the door to open:
After a beep enter on the TELPRO:
000005 08
The last 2n
o
. digits, shown as underlined, set the door open time in seconds. You can choose any length between 01 -
99 seconds. For automation control, 01 seconds is usually more than adequate.
A sharp beep confirms that you have correctly entered the above. Programming mode beep - every 4 seconds -
resumes.
STEP 2
After a beep enter on the TELPRO: 02A0
A sharp beep confirms that you have correctly entered the above. Programming mode beep - every 4 seconds -
resumes.
STEP 3
You must now set the Master Code of your choice. This is the code that allows you to access programming mode
without having to open up the Door Controller and flicking switch SW1.
The Master Code is always stored in Slot N
o
. 06.
The Master Code must be a 5 digit number, for example: 19388.
After a beep enter on the TELPRO:
A sharp beep confirms that you have correctly entered the Master Code. Programming mode beep - every 4 seconds -
resumes.
Page view 8
1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 19 20

Comments to this Manuals

No comments
  • ScanDomestic Paslode Foundations Masonite Dyras
  • Graco Baby swings Clarion Car subwoofers Delfield Ice cube makers Gigabyte Server/workstation motherboards Black Box Gateways/controllers
  • Acer W3-810 HP ZBook 15 Base Model Mobile Workstation Samsung DC49H Samsung SGH-X450 Samsung EO-MN910
  • LG LW2410HR Specifications Sheet Kawasaki 840223 User Manual Aeg BSS 18C LI User Manual Sony KDL-40ZX1 User Manual Whirlpool AKP 782 IX Instruction for Use