Pelco Door ECP290 User Manual download pdf (Page 8)

Important:

Each press of a button

is confirmed (as

received) by the

reader/receiver by a

single beep. Press the

TELPRO

™

buttons

gently.

Programming using TELPRO

™

as a remote

wire-free programmer.

Remote Programming Range:

Infra-Red Receiver 20 cms - 5 metres

Proximity Reader 5 cms - 10 cms

How to use the TELPRO:

Flick TELPRO switch to ON - Red LED on the right must light up.

(Remember to turn unit off when finished)

Point TELPRO at the reader/receiver.

Enter the Master Code and wait for the reader/receiver to start beeping every 4 seconds

Flick Programming Switch SW1 and wait for the reader/receiver to start beeping every 4 seconds

(Remember to turn off the programming switch SW1 when you have finished programming).

Follow programming instructions

Note: An incorrect programming operation is signalled by a series of 3 beeps.

Programming using TELPRO

™

as a

hard-wired programmer

How to use the TELPRO as a hard wired unit:

Insert the jack connection into the top of the TELPRO unit.

Plug the connector terminal onto J5 on ECP Door Controller.

Enter the Master Code and wait for the unit

to start beeping every 4 seconds

Flick Programming Switch SW1 and wait for the unit

to start beeping every 4 seconds

(Remember to turn off the programming switch SW1

when you have finished programming)

Follow programming instructions.

Dimensions (mm):

120L x 60W x 25D

J5 = Access Point 1

J6 = Access Point 2

ECP290/ECP200

Important:

Each press of a button is confirmed (as

received) by the Door Controller by a

single beep.

Press the TELPRO

™

buttons gently.

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 19 20

Comments to this Manuals

No comments

Pelco Door ECP290 User Manual Page 8

Comments to this Manuals