Pelco DVR DX8UP-512MBRAM User Manual

C2612M (5/06)Digital Video RecorderDX8000 DX8UP-512MBRAMInstallation Manual

10 C2612M (5/06) INCREASE PAGING FILE MEMORY SIZE Pelco recommends that you increase the paging file memory size after the DX8UP-512MBRAM module is in

PRODUCT WARRANTY AND RETURN INFORMATION WARRANTY Pelco will repair or replace, without charge, any merchandise proved defective in material orworkman

United States | Canada | United Kingdom | The Netherlands | Singapore | Spain | Scandinavia | France |

2 C2612M (5/06) Introduction The following instructions serve as a guide for the installation of the DX8UP-512MBRAM memory expansion module. PARTS LI

C2612M (5/06) 3 Getting Ready 1. Familiarize yourself with the instructions throughout this manual.2. Check that you have all the necessary parts and

4 C2612M (5/06) Figure 3. Removing Power Cord from Unit 5. Ensure that the DX8000 Series DVR and all of its components are protected against electr

C2612M (5/06) 5 Prepare Unit for RAM Installation OPEN THE UNIT CHASSIS 1. If the DX8000 is mounted in a rack, remove it and transport it to an area

6 C2612M (5/06) COMPONENT LAYOUT Figure 6 shows the location of your DX8000 Series DVR’s major components. Certain cables and components have been om

C2612M (5/06) 7 Install the DX8UP-512MBRAM Memory Module 1. Carefully remove the DX8UP-512MBRAM DIMM module from its static-safe packaging. Handle t

8 C2612M (5/06) 3. Align the DIMM module with the socket so that the notch in the module lines up properly with the break in the DIMM socket. Refer t

C2612M (5/06) 9 Reassemble the Unit 1. Replace the chassis cover using the same screws you removed from the side and rear of the unit. Refer to Figur