Pelco DVR DX8UP-512MBRAM User Manual download pdf (Page 10)

10 C2612M (5/06)

INCREASE PAGING FILE MEMORY SIZE

Pelco recommends that you increase the paging ﬁle memory size after the DX8UP-512MBRAM module is installed in the memory slot.

To increase the paging ﬁle memory size:

1. Turn on the power switch and allow the unit to start up and ﬁnd the new memory. This may take several minutes.

2. After the DX8000 application starts, log in as an administrator level user and exit to the Windows

operating system. Refer to the

Installation or Operation/Programming manuals that came with your unit for instructions.

3. In the Windows operating system environment, click Start > Settings > Control Panel. The Control Panel window opens.

4. Double-click the System Icon to open the System Properties. The System Properties dialog box opens.

Figure 11.

System Icon

5. On the General tab of the System Properties dialog box, in the Computer section of the tab, do the following:

a. Verify the correct amount of memory is installed.

b. Click > Advanced > Performance Options > Change. The Virtual Memory dialog box opens.

The Microsoft recommended setting for the paging ﬁle size is 1-1/2 times the size of the physically installed memory. For example, if

the size of the physically installed memory is 768 MB, the paging ﬁle size should be 1150 MB.

6. Assuming the physically installed memory is 768 MB, do the following:

a. Set the Initial size to 1150.

b. Set the Maximum size to 1150

c. Press the Set button.

7. Click OK to exit the windows and restart the machine if asked to.

1 2 ... 5 6 7 8 9 10 11 12

No comments

Pelco DVR DX8UP-512MBRAM User Manual Page 10