Pelco DVR DX8UP-512MBRAM User Manual download pdf (Page 9)

C2612M (5/06) 9

Reassemble the Unit

1. Replace the chassis cover using the same screws you removed from the side and rear of the unit. Refer to Figure 10.

Figure 10.

Replacing Chassis Cover

2. Attach the silver part label that came in your upgrade kit to the inside of your DVR’s front door.

a. Remove the paper backing from the part label.

b. Carefully place the label, adhesive-side down, on a free section of the inside of the door.

c. Press down ﬁrmly to ensure that the label properly adheres to the inside of the door.

NOTE:

In the event that your unit or its components require service, part labels must be present and appropriately afﬁxed to the unit’s door.

Pelco product support personnel use these labels to identify the exact components installed in your system. A separate part label is

required for each upgrade component installed on the DX8000.

3. Reinstall the unit in a rack enclosure if necessary, and reconnect all cables and peripheral equipment that you removed earlier.

4. Plug the power cord back into the power supply and then into the wall.

1 2 3 4 5 6 7 8 9 10 11 12

No comments

Pelco DVR DX8UP-512MBRAM User Manual Page 9