Pelco ES31PC User Manual download pdf (Page 53)

C311M-L (1/05) 53

<Wiper>

<Alert>

<Other>

ACK Alert

Exit

MAIN MENU

Proportional pan On

Park time minutes 0

Scan Speed deg/s 25

Pattern Length 1.5 min

Spd Profile

Exit

Other Menu

Set Azimuth Zero

Az/El

Az/El Line

Direction

Direction Line

Zoom

Zoom Line

Disp Duration

Exit

Az/El/Direction

ZOOM

Zoom programs the horizontal display position of the Zoom label. The following settings are available for the Zoom label:

Off – Label is not displayed.

Left – Label is displayed on the left-hand side of the screen.

Center (default) – Label is displayed in the center of the screen.

Right – Label is displayed on the right-hand side of the screen.

NOTE: Zoom display is not available while you are programming or running a pattern.

To program the horizontal label position for Zoom:

1. Program preset 95 (28). The main menu appears.

2. Position the cursor (>) beside Other.

3. Press the Iris Open button to enter the Other menu.

4. Position the cursor (>) beside Az/El/Direction.

5. Press the Iris Open button to enter the Az/El/Direction menu.

6. Position the cursor (>) beside Zoom.

7. Press the Iris Open button. The cursor moves to the right.

8. Move the joystick up or down to view the available selections.

9. SELECT – Press the Iris Open button to make a selection.

CANCEL – Press the Iris Close button to cancel a selection.

1 2 ... 48 49 50 51 52 53 54 55 56 57 58 ... 67 68

No comments

Pelco ES31PC User Manual Page 53