Pelco pelco is110 User Manual download pdf (Page 10)

10 C3426M-E (3/09)

8. Reinstall the back box inside the cover. For vandal-resistant installations, rotate the back box to

position the conduit plug opposite the notch on the side of the cover. Use the two 8-32 x 0.375-inch

Phillips pan head screws and washers (removed earlier) to secure the back box to the cover.

Figure 2. Basic Surface Installation

4S ELECTRICAL BOX INSTALLATION

NOTE: You should install the camera module into the back box before installing the back box into the

cover. When installing the back box into the cover, rotate the camera module to access the mounting holes

(refer to Camera Module on page 16 for more information).

1. Attach an ICS110-AP adapter plate (not supplied) to a 4S box. Use two 8-32 x 0.75-inch Phillips flat

head screws (supplied with both the IS110 and the adapter plate).

2. Remove the two 8-32 x 0.375-inch Phillips pan head screws and washers (supplied) to separate the

cover from the back box.

3. Pull the video and power wires into the cover.

4. Attach the cover to the adapter plate with up to four 8-32 x 0.375-inch Phillips pan head screws

(supplied with the adapter plate). Use stainless steel hardware when installing the system outdoors.

5. Connect the video cable and wires:

• BNC: Connect the BNC connector from the unit to a mating BNC connector.

• UTP: Connect the blue wire to Video +; connect the gray wire to Video -.

8-32 X 0.375-INCH

PHILLIPS PAN HEAD

SCREWS WITH WASHERS

(SUPPLIED)

MOUNTING

SCREWS

(NOT SUPPLIED)

COVER

BACK BOX

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 35 36

No comments

Pelco pelco is110 User Manual Page 10