Pelco DVR5300 User Manual download pdf (Page 41)

C1629M-F (3/08) 41

Appendix D: Installing an Uninterruptible Power Supply (UPS)

You should connect each DVR5300 Series digital video recorder to a UPS (not supplied). UPS devices maintain a limited amount of backup battery

power in case the main power fails. The UPS should have a minimum rating of 450 VA for each DVR5300.

Nearly any UPS device can be used to supply backup battery power. Contact Pelco’s Product Support for information about Pelco-approved UPS

devices (refer to Appendix F: Troubleshooting on page 43 for contact information).

NOTE: These instructions give general guidelines for connecting a UPS device to the DVR5300. Refer to the instructions that came with your

UPS to make sure you install the device properly.

1. Shut down the DVR5300 (refer to Unit Shutdown on page 32).

2. Connect a power cord from the UPS to a standard wall socket or other power source.

3. Connect a power cord from the UPS to either the primary or the secondary power supply on the rear panel of the DVR5300. In this

configuration, the DVR5300 will not lose power if either the power source or the UPS fails.

4. Power up the UPS device.

5. Power up the DVR5300 (refer to Unit Startup on page 31).

Figure 36. Connecting a UPS to a DVR5300

INPUT POWER

OUTPUT POWER

UPS

POWER SOURCE

mple Text

Sam

ple Te

MFG BY PELCO

, C

LOVIS,

Model

1 2 ... 36 37 38 39 40 41 42 43 44 45 46 47 48

No comments

Pelco DVR5300 User Manual Page 41