Pelco SD5 User Manual download pdf (Page 14)

14 Pelco Manual C1456M-D (10/98)

Figure 4. Compass Tool Figure 5. Conduit Fitting Installation

ATTACH SAFETY CHAIN HERE

CAUTION:

Be careful

not to cut outside of the

line. If you do, you may not

be able to install the back

box. Also, the trim ring

may not cover the hole.

NOTE:

Use the SCA1 (structural

ceiling adapter) if additional support

is required.

3.0 INSTALLATION FOR IN-CEILING MODELS

To install the dome proceed through the steps in this section, beginning with Sec-

tion 3.1, “Ceiling and Back Box Preparation.”

3.1 CEILING AND BACK BOX PREPARATION

3.1.1 Hard Ceiling

1. Locate the center point where you want to drill a hole in the ceiling.

2. Drill a hole in the ceiling using a 3/32-inch drill bit.

3. Remove the compass tool from the parts bag that came with the back box

(refer to Figure 4). Press the stud of the compass tool into the hole in the

ceiling. Insert a pencil in the hole in the other end of the compass and mark a

circle on the ceiling.

4. Carefully cut the circle out of the ceiling.

5. Remove the conduit fitting, lock nut, and safety chain bracket from the parts

bag and attach them to the back box as shown in Figure 5.

Proceed to Section 3.2, WIRING.

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 57 58

No comments

Pelco SD5 User Manual Page 14