Pelco SD5 User Manual download pdf (Page 15)

Pelco Manual C1456M-D (10/98) 15

CAUTION:

The ceiling

tile must be capable of

supporting 16 pounds

(7.3 kg) of weight. If the

ceiling tile will not support

this weight, order the

SD5-P metal panel.

CAUTION:

Be careful

not to cut outside of the

line. If you do, you may not

be able to install the back

box. Also, the trim ring

may not cover the hole.

Figure 6. Installing Back Box

Figure 7. Fastening Back Box

T-RAIL CLIP

FOR

CEILING TILE

HARD CEILING

CEILING TILE

T-RAIL CLIP

FOR

CEILING TILE

HARD CEILING

CEILING TILE

3.1.2 Suspended Ceiling

1. Remove the ceiling tile from the ceiling.

2. Locate the center point to drill a hole in the tile.

3. Drill a hole in the ceiling tile using a 3/32-inch drill bit.

4. Remove the compass tool from the parts bag that came with the back box

(refer to Figure 4). Press the stud of the compass tool into the hole in the

ceiling. Insert a pencil in the hole in the other end of the compass and mark a

circle on the ceiling.

5. Carefully cut the circle out of the ceiling tile.

6. Remove the conduit fitting, lock nut, and safety chain bracket from the parts

bag and attach them to the back box as shown in Figure 5.

7. Refer to Figure 6. Compress the spring clips on the back box with your hands

and push the back box through the hole in the ceiling tile. The spring clips will

spring out when they clear the ceiling tile.

8. Refer to Figure 7. Tighten the screws until the spring clips hold the back box

firmly to the ceiling tile. You will hear a clicking noise when the screws are tight.

Do not install the ceiling tile in the ceiling yet.

Proceed to Section 3.2, WIRING.

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 57 58

Comments to this Manuals

No comments

Pelco SD5 User Manual Page 15

Comments to this Manuals

Related products and manuals for Camera accessories Pelco SD5