Pelco C1302M-F User Manual download pdf (Page 15)

C1302M-F (11/08) 15

4. Refer to Figure 8 and do the following to install the arm of the wiper:

a. Place the supplied green bushing on the stud located behind the handle of the camera module. The bushing should be in the same

orientation as shown in Figure 8.

b. Install the wiper arm. Place the ridge of the arm in the notch of the enclosure tab and the slot of the arm over the green bushing.

5. Secure the arm of the wiper and the camera module with the supplied 8-32 Phillips flat head screw (refer to Figure 8).

Figure 8. Install Wiper Arm

6. Reinstall the back cap on the enclosure by doing the following:

a. Use your hands and turn the back cap clockwise until you can no longer turn it with your hands. The back cap should turn easily until

it comes in contact with the O-ring. If it does not turn easily the threads are not aligned and thread damage will occur.

b. Continue tightening the back cap with the supplied spanner wrench. There should be no gap between the back cap and the enclosure

when the back cap is tightened and properly installed.

c. Once the back cap is installed, secure the back cap with the set screw using the supplied 1.5 mm Allen wrench.

WARNINGS:

• To avoid thread damage carefully install the back cap to the enclosure.

• Never force the back cap onto the end of the enclosure.

• When installation is completed there should be no gap between the back cap and the enclosure.

BUSHING

SET TAB IN

CENTER POSITION

CAMERA

MODULE

HANDLE

8-32 PHILLIPS FLAT

HEAD SCREW

ARM

STUD

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 23 24

No comments

Pelco C1302M-F User Manual Page 15