Pelco Camclosure IP110 User Manual download pdf (Page 12)

12 C3432M-G (4/09)

Cover and Back Box Installation

The IP110 Series Camclosure integrated camera system mounts only to a surface. It can be wired through

the cover into a surface, electrical box, plaster ring, or through a side conduit opening.

NOTE: A

flash mount adaptor ring is available. Refer to the IP110-F Flush Mount Adaptor Installation

manual (C2238M) for installation instructions.

BASIC SURFACE INSTALLATION

1. Remove the two 8-32 x 0.375-inch Phillips pan head screws and washers (supplied) to separate the

cover from the back box.

2. Cut out the hole for the cable and wiring. Pull the cable a

nd wires through the mounting surface and

then through the hole of the cover.

3. Attach the cover to the mounting surface (hardware not supplie

d). Use stainless steel hardware

when installing the system outdoors.

4. Install the camera module into the back box before instal

ling the back box into the cover. Rotate the

camera module to access the mounting holes inside the back box (refer to Camera Module on

page 19 for more information).

5. Connect the cable and wires (refer to Wiring Tables on page 16 for information).

Figure 5. Basic Su

rface Installation

6. Reinstall the back box inside the cover. Use the two 8-32 x 0.375-inch Phillips pan head screws and

washers (removed

earlier) to secure the back box to the cover.

COVER

BACK BOX

MOUNTING

SCREWS

(NOT SUPPLIED)

8-32 X 0.375-INCH

PHILLIPS PAN HEAD

SCREWS WITH WASHERS

(SUPPLIED)

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 43 44

No comments

Pelco Camclosure IP110 User Manual Page 12