Pelco pelco is110 User Manual download pdf (Page 15)

C3426M-E (3/09) 15

8. Connect the video cable and wires:

• BNC: Connect the BNC connector from the unit to a mating BNC connector.

• UTP: Connect the blue wire to Video +; connect the gray wire to Video -.

9. Connect the power wires (refer to Table F).

AC operation only: If you are wiring more than one Camclosure to the same transformer, connect one

side of the transformer to the red wire on all units; connect the other side of the transformer to the

black wire on all units.

NOTE: Failure to connect all AC powered units in the same way will cause the cameras to be out of

phase with each other, which may produce a vertical roll when switching between cameras.

Table F. Power Input: Side Conduit Installation

Voltage Red Wire Black Wire

12 VDC + Ground

24 VAC ~ ~

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 35 36

No comments

Pelco pelco is110 User Manual Page 15