Pelco C3432M-F User Manual download pdf (Page 10)

10 C3432M-F (6/08)

Cover and Back Box Installation

The IP110 Series Camclosure integrated camera system mounts only to a surface. It can be wired through

the cover into a surface, electrical box, plaster ring, or through a side conduit opening.

BASIC SURFACE INSTALLATION

1. Remove the two 8-32 x 0.375-inch Phillips pan head screws and washers to separate the cover from

the back box.

2. Cut out the hole for the cable/wiring. Pull the cable/wires through the mounting surface and then

through the hole of the cover.

3. Attach the cover to the mounting surface (hardware not supplied). Use stainless steel hardware

when installing the system outdoors.

4. Install the camera module into the back box before installing the back box into the cover. Rotate the

camera module to access the mounting holes inside the back box. Refer to Camera Module on

page 19 for more information.

5. Connect the cable/wires (refer to Wiring Tables on page 14 for information).

6. Reinstall the back box inside the cover. Use the two 8-32 x 0.375-inch Phillips pan head screws and

washers (removed earlier) to secure the back box to the cover.

Figure 5. Basic Surface Installation

COVER

BACK BOX

MOUNTING

SCREWS

(NOT SUPPLIED)

8-32 X 0.375-INCH

PHILLIPS PAN HEAD

SCREWS WITH WASHERS

(SUPPLIED)

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 39 40

No comments

Pelco C3432M-F User Manual Page 10