Pelco IS150 User Manual download pdf (Page 26)

26 C3427M-D (2/09)

Install Liner and Trim Ring

1. Adjust the liner (if installed), refer to Figure 15:

a. Align the screw holes in the trim ring with those in the back box to identify the proper liner

position.

b. Loosen the three Phillips screws located in the trim ring.

c. Insert the blade of a standard screwdriver in one of the adjustment grooves. Rotate the liner

to position the viewing window over the camera lens.

d. Tighten the three Phillips screws to lock the liner in place.

Figure 15. Adjusting the Liner

2. Place the trim ring onto the back box.

3. Tighten the tamper-resistant screws through the trim ring into the back box. Use the 1/8-inch hollow

screwdriver bit (supplied).

NOTE: The screws are installed at an angle.

LOOSEN SCREWS

ADJUSTMENT

GROOVE

LINER

1 2 ... 21 22 23 24 25 26 27 28 29 30 31 32

No comments

Pelco IS150 User Manual Page 26